5
lippert.com 432-LIPPERT (432-547-7378) Rev: 09.23.21
Flow Max
TM
Faucets
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0001241
Operation
Fixed Faucet
1. Pull the lever away from the faucet to turn it on (Fig.9A).
5. Slide the black plastic collar back onto the supply lines,
inserting one supply line at a time.
NOTE: Make sure the inside threads of the black plastic
coupler are at the top.
6. Screw the black plastic collar all the way up the faucet
base until it will no longer turn (Fig.8A).
NOTE: The red marked supply line is for hot water and the
blue marked supply line is for the cold water.
7. Thread the nut on the hot water supply line onto the hot
water outlet supply valve and tighten with an adjustable
wrench. Do not over tighten.
8. Thread the nut on the cold water supply line onto
the cold water outlet supply valve and tighten with an
adjustable wrench. Do not over tighten.
9. Turn the hot and cold water outlet supply valves back on
and check for any leaks.
2. Move the lever towards you for hot water (Fig. 10) and
away from you for cold water (Fig. 11).
NOTE: Located on the front of the lever is a “H” for hot
water and a “C” for cold water. Move the lever in the
direction of the desired temperature.
A
right profile
view
right profile
view
A
Fig.8
Fig.9
Fig.10 Fig.11
To Next Page
Loading...