Lippert JT's Strong Arm Travel Trailer - Tools and Resources Required for Installation; Preparation for Installation; Site Preparation; Installation Guide

4
lippert.com 432-LIPPERT (432-547-7378) Rev:06.30.22
JT’s Strong Arm
™
Travel Trailer
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-002345
Preparation
1. 
2. Clear all jack landing locations of debris and

3. 
4. 

5. 
operating leveling system.
Resources Required
Installation



If the chassis has scissor jacks (Fig.1) installed, proceed

the chassis has electric stabilizer jacks (Fig.2) refer to the
Installation for Electric Stabilizer Jacks section.
Fig.2
Rear electric stabilizer jack
Fig.1
Scissor jack
• 
• Felt-tip black marker
• 
• 
• Electric or cordless drill

• ⁄
(for pilot holes)
• ⁄
• ⁄
• ½
preferredstandard ½
drill bit acceptable
• 

• ⁄
• ⁄
• ⁄
• ⁄
• Locking pliers
• 
• White grease
• Safety glasses
• Face shield
• 
THE TRAILER MUST BE SUPPORTED PER THE
MANUFACTURER’S RECOMMENDATIONS BEFORE
WORKING UNDERNEATH. FAILURE TO DO SO MAY
RESULT IN DEATH, SERIOUS PERSONAL INJURY OR
SEVERE PRODUCT OR PROPERTY DAMAGE.
Installation for Scissor Jacks
1. 


(Fig.3).
Fig.3
6”