Lippert THEATER SEATING - Disconnecting Power Wires and Seat Cushion; Removing Mechanism Base from Footrest Kick Plate; Removing LED Light Assembly

Rev: 04.30.21 Page 2 CCD-0004339
THEATER SEATING
MECHANISM REPLACEMENT
TI-397
FURNITURE
5. Located in between the back and seat cushions are connecting power wires (Fig. 3A). Disconnect the
two wire connections.
6. Utilizing another person, pull the tab on the latches (Fig. 4A) out on both sides of the seat cushion
(Fig. 5A) while lifting the back cushion up and off from the theater seat. Place the back cushion (Fig. 5B)
aside, on a clean surface for re-installation.
7. Flip the theater seat cushion (Fig. 5C) upside down to work on removing the base mechanism.
8. Remove the four bolts holding the mechanism base to the foot rest kick plate, two on each side (Fig. 6A).
9. To remove the LED light (Fig. 7B), cut the zip ties (Fig. 7A) holding the wire to the mechanism base.
10. Slide the LED light (Fig. 8A) down and off the mechanism base.
Fig. 4
A
Fig. 6 Fig. 7 Fig. 8
A
A
B
A
A
Fig. 3
A
Fig. 5
A
B
C