Lippert THEATER SEATING - Disconnecting Additional Wires and Base Mechanism; Lifting and Setting Aside Base Mechanism

Rev: 04.30.21 Page 3 CCD-0004339
THEATER SEATING
MECHANISM REPLACEMENT
TI-397
FURNITURE
11. Disconnect the LED wire (Fig. 9A) from the power harness.
12. Disconnect the AC/DC power adapter wire (Fig. 10A).
13. Disconnect the motor wire (Fig. 11A) and remove from the zip ties holding it in place to the
mechanism base.
14. Remove the screws (Fig. 12A), two on the side of the theater seat without the arm, holding the base
mechanism to the theater seat. Place the screws aside for installation of the new mechanism base.
15. Remove the screws (Fig. 13A) three on the side of the theater seat with the arm, holding the base
mechanism to the theater seat. Place the screws aside for installation of the new mechanism base.
16. Lift the base mechanism up and set aside.
Fig. 9 Fig. 10 Fig. 11
A
A
A
Fig. 12
A
Fig. 13
A