Lite-Puter CX-1204 - CX-1204 Operation; Scene Setting; Scene Recall

To Next Page

To Previous Page

ISO 9001 CERTIFIED

Lite-Puter

CX-1204 [EUM-A]

Chapter 2. CX-1204 operation

2-1 Scene Setting

STEP-1 press【SC / CH】to select the control channel

LED : off Æ in CH mode

LED : on Æ in SC mode

STEP-2 move【MASTER-VR】to the top

STEP-3 move【VR-1 … VR-12】to dimming

STEP-4 press【PROG】+【1…12】to confirm and save the selection

2-2 Scene Recall

Refer to 2-1 to set up the dimming value of SC-1…SC-12, use the following

function to recall the scene.

A: 0%…100% VR control

STEP-1 press【SC / CH】key to select【SC】mode. (LED ”on”)

STEP-2 press【VR-1…VR-12】

Ex : to recall SC-2, adjust the【VR-2】, to recall scene 2 by dimming

B: FLASH

STEP-1 press【SC / CH】to select【SC】mode. (LED ”on”)

STEP-2 press【1…12】

EX : to recall SCENE 2, press【2】,and scene 2 switch to 100% full, and release the

key to off the function.

1.) When MASTER-VR in 100%, and the VR-1…VR-12 in 50% of dimming value,

the SCENE total output dimming value will be 50%.

2.) When MASTER-VR in 50 %, and the VR-1…VR-12 in 50% of dimming value,

the SCENE total output dimming value will be 25%.

Select【CH】mode, and move the fader to set the dimming value

press【PROG】+【1~12】 to save control scene.