Need help?Do you have a question about the Litecraft BeamX.7 IP and is the answer not in the manual?
Key safety directives for device operation, covering heat sources, temperature changes, electrical connections, and cable integrity.
Highlights risks of burns from hot surfaces and health risks from direct light exposure, especially for epileptics.
Specifies the product is a spotlight for professional use on stages, discotheques, and theatres, suitable for outdoor use but not permanent installation.
Advises on avoiding shocks, managing ambient temperatures, securing cables, and maintaining air vents and connectors for proper operation.
Mandates qualified personnel for installation, use of safety chains, securing the fixture, and respecting load capacities and safety distances.
Emphasizes the need for experience in overhead installations, using professional truss systems, and securing fixtures with safety chains.
States that mains connection is only allowed by skilled persons and requires checking specifications and using electrical grounding.
Details maintenance by skilled persons, checking screws and cords, sealing unused connectors, and cleaning the unit with a damp cloth.
Explains DMX and standalone modes, including slave mode setup, and describes display and button functions for device control.
Details the use of the infrared remote control for selecting colors or programs, and how to exit infrared mode.
Covers resetting parameters to factory defaults and setting the DMX start address for device communication.
Explains how to set DMX channel modes and choose from different dimmer curves for lighting effects.
Details working modes (Master/Slave) and setting brightness for individual colors (Red, Green, Blue, White).
Describes pre-programmed color combinations (ColMac) and chaser sequences (ColProgr) available for lighting effects.
Covers setting speed for chasers, adjusting white balance, and managing display lock and backlight behavior.
Details functions for 2-channel (color macro, master dimmer) and 3-channel (RGB dimming) DMX modes.
Explains DMX functions for 4-channel (RGBW dimming), 5-channel (RGBW + master dimmer), and 10-channel modes.
Presents illuminance (lux) values for Red, Green, Blue, White, and RGBW at different distances (1m, 3m, 5m).
Details optics, beam angle, LED sources (7x multichip LEDs), colors (RGBW), and LED lifetime (>50,000 hours).
Outlines control protocols (DMX512, IR), channels, internal memories, and technical data like mains voltage and power consumption.
Specifies housing material (aluminium), color (black), IP rating (IP 65), physical size, and weight (3.5 kg).
Certifies conformity with the Low Voltage Directive 2014/35/EU, listing tested standards like EN 60598 series.
Confirms compliance with the EMC Directive 2014/30/EU, referencing tested standards such as EN 55032 and EN 61000 series.
General| Light Source | 7x 40W RGBW LEDs |
|---|---|
| Power Consumption | 350W |
| IP Rating | IP65 |
| Pan | 540° |
| Tilt | 270° |
| LED Type | 40W RGBW |
| Operating Voltage | 100-240V AC, 50/60Hz |
| Type | Moving Head |
| Control Protocol | DMX, RDM |
To Next Page