LiteHawk RANGER - During Charging; How to Start

LiteHawk RANGER Instruction Manual 5
During charging:
- It is normal for the battery to get warm during the charging process. Do not charge the
battery on a surface that is flammable or can be damaged by heat.
- Do not leave the battery and charger unattended while charging.
- Do not store the battery plugged into the charger or model
How to Start!
LiteHawk RANGER is ready to use - however you must follow these
steps carefully:
1. Switch ON the transmitter.
2. Plug in the battery into the RANGER.
3. Turn the RANGER power switch ON.
Installation of battery into the RANGER:
Place your RANGER on a clean flat surface. Avoid areas where small parts may be lost.
- The battery is housed in the battery compartment located on the top front.
- Turn the locking tabs to release the battery cover
- Gently lift the battery cover off the hovercraft.
- Place your fully charged battery in the battery compartment. Connect the battery connec-
tor. Don’t force it, it only goes one way!
- Replace the compartment cover.
12 3
45 6