WCBN814A User Manual
Page 4/21
separation with the antenna while this end product is installed and operated. The end user has to be
informed that the FCC radio frequency exposure guidelines for an uncontrolled environment can be
satisfied. The end user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this equipment. If the size of
the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required to be
available in the users manual: This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2) this device must
accept any interference received, including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains FCC ID: PPQ-
WCBN814A ". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19
statement has to also be available on the label: This device complies with Part 15 of FCC rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference
and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
OEM Integrator Checklist
The party below will implement the LITE-ON Module in host systems in accordance with the
instructions specified in this document and the documents referenced herein.
1. The OEM integrator will ensure the Module is integrated in a host systems using only the approved
antenna model(s) described in this document.
2. The OEM integrator will ensure the antenna placement inside the host system will maintain the
required spacing to end user for RF Exposure compliance, as specified in this document.
3. If other radios are integrated inside the host with the LITE-ON Module, the OEM integrator will
contact its test lab, TCB or LITE-ON to determine if additional FCC compliance evaluation is
required to meet FCC collocation rules.
4. The OEM integrator will ensure end user documentation will contain the specified regulatory
wording and ensure the host system and the Module itself are labeled as specified in this document.
5. The OEM integrator will ensure the Module is programmed in the factory with compliant transmit
power not exceeding the levels specified in this document.
LITE-ON requests that the OEM integrator acknowledge its receipt of this document and the above
instructions. You may contact LITE-ON with any questions concerning this document or the
responsibilities of the OEM integrator.
IC Statement:
This device complies with Industry Canada license exempt RSS standard(s). Operation is subject to the
To Next Page
Loading...
Need help?
General