Litmor Capsule - Step 1: Shut power off at the breaker; Step 2: Remove the existing floodlight

󾗸 󾗹
STEP 2/7
Remove the existing
oodlight
Make sure the breaker is
power o󽗈.
Disconnect the wires and
remove your existing 󽗊oodlight
from the junction box.
If there is a bracket attached to
your junction box, remove that
as well. Check your junction
box to make sure water cannot
get into it.
Junction box
Tips: Litmor
TM
Capsule DO NOTrequire ground wire
connection because its bracket is made of plastic.
STEP 1/7
Shut power off at the breaker
If you do not know where your breaker is or how to turn o󽗈 power
to your 󽗊oodlight circuit, hire a .
CAUTION: Risk of 󽗉re.
DO NOT install near combustible
or 󽗊ammable.
WARNING: Risk of electrical shock.
Disconnect power at the fuse or circuit breaker.
Verify that the supply voltage is correct.
Connect 󽗉xture to a 100V ~ 240V AC 50/60Hz
power source.
Ensure proper ground 󽗉xture.
Always follow code standards when installing
wired connections.
1
2
3
4