Why is the suction power of my Living & Co LVC2000BM weak?
If the suction power of your Living & Co Vacuum Cleaner weakens, here's what to do: 1. Check the hose, floor brush, and tube for any clogs or damage. If you find an obstruction, remove it immediately. 2. Empty the dust tank if it's full. 3. Inspect the filter for clogs and ensure the tube is correctly attached. Clean the filter or reassemble the tubes as needed.
What to do if the power cord of my Living & Co LVC2000BM Vacuum Cleaner will not pull out?
If the power cord of your Living & Co Vacuum Cleaner won't pull out, it might be twisted. Try pulling out the power cord to its maximum length and then rewind it.
Why the power cord of my Living & Co Vacuum Cleaner cannot be pulled out?
If the power cord of your Living & Co Vacuum Cleaner cannot be pulled out, it may be twisted. Rewind or pull the cord in and out several times by pressing the cord rewind button.
Steps for connecting the hose, tube, and vacuum head before operating the appliance.
Instructions on how to empty the dust canister of the vacuum cleaner when full or suction is reduced.
Guidance on cleaning and replacing filters to maintain vacuum performance, recommending annual replacement.
Instructions for removing and washing the air outlet filter, emphasizing complete drying before reinstallation.
Instructions for safely rewinding the power cord using the rewind button after unplugging the appliance.
Guidance on storing the floor brush with tubes in the appliance's storage clip at the rear.
Explanation on how to use the dual position carpet/floor brush and the dusting/crevice tools effectively.
Guidelines on how to dispose of the appliance responsibly at the end of its life to protect the environment.
General| Model | LVC2000BM |
|---|---|
| Category | Vacuum Cleaner |
| Power | 2000W |
| Dust Capacity | 2L |
| Cord Length | 5m |
To Next Page
