LM048/LM058 Quick Start Guide v1.3
©2012 LM- Technologies Ltd www.lm-technologies.com Page 2 of 8
3. Make sure the LM149 Software is installed on the PC. Alternatively
you can also use a serial terminal program like Hyperterminal,
Putty or Teraterm to configure the adapter using AT Commands.
For complete list of AT Command refer LM048&LM058 User
Manual.
4. Launch the LM149 Software, select the correct COM Port and
Serial Port Settings and press “Read Settings”. The default serial
settings on LM048 and LM058 are 19200 8 N 1 Flow: None.
For the old v4.5x series firmware, the default serial settings are
19200 8 N 1 Flow: Hardware.
5. If the user doesn’t know the serial settings on the adapter, then
LM149 Software will try all serial settings and find the correct
settings. Once the communication with the adapter is established
the LM149 Window will be populated with the settings as shown
below
6. Once the communication has been established, user is free to
change the settings on the window and press “Save Settings”. This
will save the modified settings to the adapter.
7. After the settings are saved, the adapter can be plugged to any
serial device and will work as a standalone plug and play unit.
To Next Page
Loading...
Need help?
General
