Loewe Assist Multi-Control - Setting the STB Button; Brand List; Factory Settings

- 26
English
Setting operating mode
Setting the STB button
Brand list
The button with the STB function can be set to the desired device with a
3-digit number.
Press the STB button for at least 5 seconds.
The LED above the STB button flashes twice.
Enter code 003.
The LED above the STB button flashes twice.
Enter the three-digit code from the Brand list of page
189.
Press the On/Off button until the device to be operated
reacts to the inputs on the remote control.
Press the OK button.
➠ When entering an invalid code the LED lights up for 2 seconds.
➠ The setting procedure is cancelled after 10 seconds without a code
input.
➠ In addition to the STB button you can also assign the STB function to
the DVD and AUDIO buttons (page 25).
➠ If you do not find a code with which you can operate your STB device
in this search, make the Internet Update (page 27).
Factory settings
The STB/DVD/AUDIO button can be reset to the factory settings.
Press the button for at least 5 seconds.
The LED above the button flashes twice.
Enter code 000.
The LED above the button flashes twice.
_33153_Assist_STB_Buch_DE-SE.ind26 26_33153_Assist_STB_Buch_DE-SE.ind26 26 23.01.2008 14:36:3723.01.2008 14:36:37