What to do if Lofa CANplus 750 beeps for longer than 1 second?
If the Lofa Control Panel's display beeps for longer than 1 second, indicating a self-test fault, you can attempt to fix it by restoring the factory defaults. See the Configuration Menu for instructions on how to do this.
Explains the meaning and usage of safety symbols like Danger, Warning, and Caution.
Clarifies the purpose and limitations of the auxiliary engine stop feature.
Warns about auto-start system risks and emissions compliance responsibilities.
Describes various throttle control types including Ramp, Two-State, Three-State, and Digital Rotary.
Detailed explanations of Ramp, Two-State, Three-State, and Digital Rotary throttle functions.
Describes the different modes controlling automatic start/stop operation.
Defines the functions used to control level or pressure for start/stop events.
Details how to enter and navigate the main Configuration Menu.
Configures display items like language, button beep, gauges, and service.
Sets display units for speed, distance, pressure, volume, and temperature.
Enables simulated data modes for testing and demonstration purposes.
Resets all configuration information to default US or Metric units.
Uses Com Viewer and J1939 Viewer for diagnostics and data inspection.
Selects the data source the display listens to for gauge data.
Sets the unique address for the display on the CANbus.
Configures alarm filtering and Suspect Parameter Number conversion method.
Selects the source for speed data decoding.
Enables or disables PIN entry for accessing the Configuration Menu.
Selects operating modes and functions for automatic start/stop.
Configures Idle, Intermediate, Run RPMs, and ramp profiles for throttle control.
Configures servo gain and delay for maintain modes.
Sets transducer type, range, set points, and dead band.
Configures restart attempts and delays for the starter.
Configures governor mode and CP750 CAN address.
Calibrates tachometer input for mechanically governed engines.
Selects Aux Output function and provides 1 amp low side switch options.
Configures set points for transducer alarm messages.
Sets J1939 and Modbus addresses, and views telemetry status.
Describes the meaning of the Green, Amber, and Red status LEDs on the control panel.
Provides guidelines for handling sealed and unsealed connectors and recommendations for grease usage.
Specifies minimum routing radius and bend avoidance for wiring harnesses.
Details power connection recommendations, grounding, and polarity considerations.
Explains voltage drop effects on control system reset and common causes.
Outlines safe procedures for welding on equipment with electronic controls to prevent damage.
Lists common causes and remedies for control system self-test failures.
Addresses issues where the engine cranks, runs, and then shuts down.
Lists causes and remedies for the display not showing data or showing inaccurate RPM.
Provides a procedure to test CANbus integrity and identify connection problems.
Lists common Suspect Parameter Numbers and Failure Mode Identifier codes with their interpretations.
Lists electrical, fuel, and distance parameters monitored via CANbus.
Lists pressure and temperature parameters monitored via CANbus.
Lists percentage, speed, and time-related parameters monitored via CANbus.
General| Brand | Lofa |
|---|---|
| Model | CANplus 750 |
| Category | Control Panel |
| Language | English |
To Next Page
