the possibility of electric shock (see “Replacing
the light bulb”)
To clean the appliance, refer to the
corresponding chapter in this manual.
This instruction manual is also available on the
website www.lofra.it
1. INSTALLATION
Installation, regulation, transformation and maintenance procedures must be done by
qualified personnel in accordance to this manual and laws in force. The company will not
be liable for any type of damage derived from improper voltage or other misuse,
abnormal service or handling and alterations or modifications in design or construction..
The equipment you purchased is designed to fit into a standard enclosure approximately
900mm wide (90 ovens). The enclosure, adjacent furniture, and all materials used for
installation must be capable of withstanding a temperature of 150°C (302°F) and
adequate ventilation must be provided to prevent overheating. In addition, adjacent
furniture doors must not interfere with the oven.
WARNING
Check that the electrical system meets the requirements shown on the data plate of the
appliance.
1.1 CHOOSING A LOCATION FOR YOUR OVEN
The unit can be fitted either underneath a work surface or in a column unit.
Fitting measurements are shown in the pictures below..
Ovens door need to be fitted using 4 screws
Don’t lever against the oven door during the installation process.
To Next Page
Loading...
