69
• OVEN UP
Traditional cooking with heat propagation from
above and from below. With the same knob is
possible to set the temperature till a maximum of
260°.
Cooking from below with a maximum temperature
not over 260°C; this position is ideal for cooking
with sauces.
Cooking from above with maximum temperature
fixed on 260°; this position is ideal for soft cooking
(grating) and grilling (toasted bread).
Cooking from above with maximum temperature
fixed on 260°; this position is ideal for fast grilling
(red meat) or gratin dishes.
3.7. COOKING HOB WITH GLASS-PLATE (Applicable models only)
Switching on
The control is switched on by pressing ( x sec.) the on/off key a beep sounds. It will not
come on if the key lock function is activated (indicated by a pilot light).
The heaters remain off (all the digits show 0) until a power level is selected. If the selection is
not made in 10 seconds, and if the timers are off, the control turns off automatically.
Selecting a power level for a certain heater
With the control on, the first time the sensor (+) is pressed ( x sec), the heater switches on at
level 1 by default (configurable).
The sensor (+) raises the cooking level to a maximum of 9, whereas the sensor (-) reduces the
cooking level to 0 (heater off).
With the heater at position 0, the sensor (-) raises the cooking level to 9.
If the sensor is held down, the action is repated twice every second.
Activating the heat-up function
This function takes the cooking level to maximum power for a defined time.
The heat-up function is activated selecting the power level 9, and touching the (+) key. The
decimal point of the display blinks for 10 seconds. During these 10 seconds the desired power
level must be selected (between 1 and 8). After this time a beep sounds, and the decimal point
remains fixed, indicating the heat-up function is ON. If the power level is 0 or 9, the heat-up
function is cancelled. If the heat-up function is activated, pressing the heater (+) key, the
duration of the heat-up function will be the duration for the new power level; if the new level is 9,
the heat up function is cancelled.
To Next Page
Loading...
