15
THROTTLE PARK
The mower deck is fitted with a throttle park. To use the throttle park clip the throttle to the
bracket as shown below.
DO NOT USE THE THROTTLE PARK DURING OPERATION. THE THROTTLE
SHOULD BE POSITIONED NEAR THE OPERATOR DURING WORKING CONDITIONS.
THROTTLE PARK IS FOR STORAGE WHEN THE MOWER IS NOT IN USE ONLY
STOPPING THE ENGINE
When stopping the mower after a period of heavy use. Run the machine at half working speed
in a stationary position for at least 4 minutes to allow the drive belts/clutch to cool down.
Shut the throttle down to lowest RPM and switch off engine.
1. Show caution to hot parts e.g. engine exhaust, belts etc after engine is switched off.
2. When the mower has cooled down (Min1hr after last used) Ensure all grass has been
removed from engine cooling fins, drive belt area and rotors before operating again.
TRANSPORT POSITION
When the mower is being moved from one site to another it is advisable to raise the deck to the
highest position (See section called ‘mower cutting height’)
The engine must be stopped and the blades at a standstill before adjusting to the transport
position. (Transport position is the highest deck setting available).
Remove any crop particles from the deck before leaving the field. Never move from one site to
another with the engine running. Ensure the mower drawbar has been adjusted to allow the
mower to run directly behind the towing vehicle and is not in an offset position
NB: TRM – Rotary mower is not road legal, and should not be used on public roadways.
If you have any specific questions regarding mowing or adjusting the TRM120 to suit your
conditions please contact Logic
To Next Page
Loading...
Need help?
General