19
WHEEL BEARING INSPECTION
Jack one side of the mower body up, so the wheel is just off the ground. Rotate the wheel by
hand, and check the wheel alignment. To check the bearings, try to move the wheel from left to
right and feel for any play in the bearings (A), ensure the wheel-locating bolt is tight before you
start and follow any jacking procedures. If any play is found remove the wheel and inspect
bearings. Replace any faulty bearings.
OIL COUPLING / COUPLING BUSH WEAR
Check coupling for signs of damage or wear, swivel the coupling 360 degrees and check that
the yellow bushes aren’t to worn. Replace any warn or damaged parts. Oil the coupling regularly
GENERAL INSPECTION
Check the mower to ensure all fasteners are tight and all safety guards / chains are intact and
fitted securely. Check all safety-warning decals, Replace any defected guards or decals.
SHARPEN ROTOR BLADES
To remove the individual blades:
1. Disconnect the spark plug.
2. Block the blade to prevent it from rotating by using a block of wood. (A)
To Next Page
Loading...
Need help?
General