Logik L17MSW13E

35
GB
Clock Setting
When the microwave is connected to the mains power, the LED display will show ”0:00” and the microwave
will sound once. Please ensure that you have set the clock prior to use.
Please follow the steps below to set the clock.
1. Press the Clock/Pre-Set button, the hour digits will
ash. The unit will also beep.
2. Turn the Timer/Weight/Auto Menu dial to adjust the
hour digits. The input time should be within 0-23.
3. Press the Clock/Pre-Set button, the minute digits will
ash. The unit will also beep.
4. Turn the Timer/Weight/Auto Menu dial to adjust the
minute digits. The input time should be within 0-59.
5. Press the Clock/Pre-Set dial to nish clock setting. The
unit will also beep.
“:” will start ashing and the time will illuminate.
• This is a 24-hour clock. When the microwave
is connected to the mains power for the rst
time or when the power is resumed after a
power interruption, the LED display will show
“0:00”. To re-set the clock, simply follow the
above 5 steps.
• In the process of clock setting, if the stop/clear
button is pressed or if there is no operation
within 1 minute, the microwave will go back to
the previous status automatically.
• If the clock needs to be reset, please repeat
steps 1 to 5.
• To nd out the current time while the
microwave is operating, press the clock/pre-
set button. It will last for 3 seconds and then
return to its original display.
Start/
+30Sec./Conrm
T
i
m
e
r
W
e
i
g
h
t
A
u
t
o
M
e
n
u
Clock/Pre-Set Stop/Clear
Microwave
Weight/
Time Defrost
1,3,5
2,4
L17MSW13E_IB_5L_Final140403.indb 35 3/4/14 6:40 pm