10
Basic Operation
Powering ON/OFF
When you first connect the unit to the mains socket. The unit will be in STANDBY mode.
• Press the
STANDBY button to switch the unit on.
• Press the
STANDBY button again to switch the unit off.
• Disconnect the mains cable from the mains socket if you want to switch the unit off
completely.
Selecting Modes
Press the DAB/FM button repeatedly to switch between modes (DAB/FM).
Adjusting the Volume
Press the VOLUME +/– buttons to adjust the volume.
Setting the Time
When you first turn on your radio it will automatically set the time by searching out the DAB
signal. It will continue to search for the clock whilst in DAB mode until it has managed to set the
time. If after 10 minutes the clock has not automatically set itself try repositioning the radio to
get a better reception.
Alarm Clock and the Wake-up Mode Settings
This unit incorporates an Alarm function. You can have an alarm wake-up time and wake-up
mode setting to wake you with a buzzer tone, or your favourite radio station.
Setting the alarm clock in STANDBY mode or ON mode.
1. Press the ALARM/SNOOZE button and hold it for a few seconds.
The display will shows “Alarm Setting Time” and the hour digits
will flash.
2. Press the
buttons to adjust the hour digits, and then press the
SELECT button to confirm.
3. The minute digits will flash. Press the
buttons to adjust the
minute digits, and then press the SELECT button to confirm.
4. The wake-up mode settings will flash on the display. Adjust DAB
& FM Preset / Buzzer Tones / Alarm Wake-up Volume Level by
pressing the
buttons. Press the SELECT button to confirm.
To Next Page
Loading...
Need help?
General
