10
4. To replace the glass, place it back in, placing the securing
caps over the top of the glass and screw it back into place.
5. Ensure the glass is not damaged in any way.
1. Turn off the oven and make sure that it is cold. Switch off its
isolation switch.
2. After removing the cover in front of the light, take out the bulb.
3. Insert the new bulb, which should be resistant to 300°C. For
replacement bulbs contact your local service centre or Partmaster
Direct (details at the back of this guide).
4. Re-fit the cover.
5. If in any doubt, consult a qualified electrician for help.
Removing the Door for Easier Cleaning
1. We recommend you have someone to assist you during removal of
the door.
2. Open the door completely.
3. The door hinge has a small latch. Lift the latch on both hinges.
4. Lift the door slightly as if closing, and then with both hands
supporting the door, pull it away from the oven.
5. To replace the door, perform the above in reverse order. Ensure
the slot on the bottom of the hinge is seated when refitting the
door. Open and close the door to make sure that it has been fitted
correctly.
Taking Out the Glass from the Oven Door for Cleaning
1. Remove the oven door.
2. Undo the screws from the metal panel that holds the glass
in place.
3. Lift the glass out of the frame. Clean it using appropriate
glass cleaning products.
Replacing the Oven Light
Ensure that the appliance is switched off before replacing the
light to avoid the possibility of electric shock.
It may require a little force due to the adhesive pads under glass.
Take care when handling parts with glass, knocks and chips; heavy handling and dropping could
cause the glass to shatter.
LBFANW_B_X12_IB_120531_Annie(Check).indd 10 12年5月31日 下午8:01
To Next Page
Loading...
Need help?
General
