20
5. Install one end of the drain hose at the back of the machine. Fit with the clamp and tightened with a
screwdriver. Fix and secure the other end of the drain hose into a sink or bucket with the suction cup.
• Do not bend your drain hose.
• Do not lift the drain hose higher than 10 cm from the table top, otherwise the unit may not be
able to expel the waste water properly.
• Ensure the water inlet and drain hoses are not kinked or squashed. The unit must not stand on
the mains cable.
• The electrical connection conditions must correspond with the specications on the rating
plate of the dishwasher. Do not use extension cables.
or
LDW2PB19N_IB_5L_Final190531.indb 20 31/5/2019 6:00 PM
To Next Page
Loading...
