19
1. Ensure there is clearance each side of the unit to
allow slight sideways movement for servicing when
required. Do not block the ventilation outlet on the
right side of the unit.
2. Do not connect the unit to the mains socket before
installation. Ensure you are not installing the unit
right in front of the mains socket. This is to avoid
potential damage to the back of the unit.
After installing the appliance, ensure that the mains
plug is easily accessible.
3. Position the unit next to a water tap and a drain.
Location
When selecting a position for your dishwasher you should make sure the installation surface is at and rm,
and the room is well ventilated. Avoid locating your dishwasher near a heat source, e.g. cooker, boiler or
radiator. Extreme cold ambient temperatures may also cause the appliance to not perform properly. This
dishwasher is not designed for use in a garage or outdoor installation.
Do not drape the dishwasher with any covering. When installing, ensure that free space is left at the sides.
4. This unit MUST BE connected to COLD WATER
MAINS using the new water inlet hose. OLD HOSE
SETS MUST NOT BE RE-USED. The water pressure
from the water mains needs to be at a minimum of
0.04 MPa and a maximum of 1.00MPa.
Alternatively, you can also pour cold water into the
dishwasher tank manually. Turn on the dishwasher
rst. Open the cap on top of the unit and pour
water into it.
• If there is not enough water in the tank,
will
light up.
• If the dishwasher tank is full, the unit will beep.
All parts removed must be saved to do the reinstallation in the future. Ensure the dishwasher is
unplugged and empty. We recommend that 2 people handle the dishwasher during installation.
Installation
or
LDW2PB19N_IB_5L_Final190531.indb 19 31/5/2019 6:00 PM
To Next Page
Loading...
Need help?
General
