37
GB
Switching O the Unit
To save energy, remember to switch the dishwasher off using the Power button. The dishwasher will
continue to use electricity until it is switched off with the Power button.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip more easily
when they are hot. Therefore, if you open the dishwasher door fully after switching off, it will allow the
dishes to cool down much faster.
Delay Start
The starting time of a washing programme can be delayed and adjusted. Please follow the steps below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Close the door. Press the Power button to turn on the dishwasher.
3. Select your preferred programme.
4. Press the Delay Start button repeatedly to select your desired delay period (range up to 24 hours).
5. The unit will start the programme at the assigned time automatically.
Half Load
In case you do not have enough dishes for a full load, the half load option can be selected for washing. This
will save hot water and electricity usage. Please follow the steps below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Close the door. Press the Power button to turn on the dishwasher.
3. Select your preferred programme.
4. Press the 1/2 Load button.
5. The unit will start the programme shortly.
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday,
disconnect the unit from the mains supply.
Unload the lower basket first, followed by the cutlery basket and then the upper basket. This will
prevent water drops from the upper basket from falling on to the dishes in the lower basket.
Each press of this button increases the delay start time by 1 hour increments.
LDW45W15N_IB_5L_Final150223.indb 37 23/2/15 4:55 pm
To Next Page
Loading...
