Logik LDW60W11N

10
INSTALLATION
GB
8. Make sure your plumbing is suitable for use
with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using the
new water inlet hose. OLD HOSE SETS MUST
NOT BE RE-USED. The water pressure from
the water mains needs to be at a minimum of
0.04 MPa and a maximum of 1.00 MPa.
• Connect the safety supply hose end with
the aqua stop to the water mains and then
connect the other end to the dishwasher.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
• Do not bend your drain hose.
You may use a Y-adaptor (not included)
for an additional water feed for another
appliance, for example a washing
machine. This is only applicable for cold
water mains. A Y-adaptor is available
from most DIY stores.
About the Safety Supply Hose
The safety supply hose consists of a
double wall construction. The hose’s
system guarantees its intervention by
blocking the flow of water in case of the
supply hose breaking and when the air
space between the supply hose itself
and the outer corrugated hose is full of
water.
water mains
Y-Adaptor
(not included)
Connect
to another
appliance if
required.
safety water supply hose
• You may use the U-shaped drain hose
holder to secure your drain hose and to
avoid bending it.
U-shaped drain hose
holder
water drain hose