16
Installation
The cooker must be installed by a competent person. If in doubt consult a qualified electrician, and follow all
local electrical, safety and building regulations.
If the cooker is installed adjacent to furniture which is higher than the hob, a gap of at least 150 mm must be left
between the side of the cooker and the furniture unless non-combustible materials are used which then allows
this distance to be reduced to 20 mm.
The furniture walls adjacent to the cooker must be made of heat resistant material. The veneered synthetic
material and the glue used must be resistant to a temperature of 50°C more than room temperature in order to
avoid ungluing or deformations.
The cooker should be located in a kitchen, a kitchen/diner or bed-sitting room but not in a room containing a
bath or shower.
Curtains must not be fitted immediately behind the cooker or within 500 mm of the sides.
This cooker must NOT be placed on a pedestal or base.
It is essential that the cooker is positioned as stated or freestanding, ensuring the distances to flammable
materials etc. are still observed.
Any cooker hoods must be installed according to the requirements of the cooker hood instruction/installation
manual.
Do not place near to a refrigerator.
500 mm
X
500 mm
900 mm
420 mm
700 mm
640 mm
Cupboard
500 mm
X
500 mm
900 mm
420 mm
650 mm
640 mm
Cooker HoodCupboard
Remarks:
X : 150mm for combustible materials
20mm for non-combustible materials.
LFSTC50W_IB_110420.indd 16 20/04/2011 3:49 PM
To Next Page
Loading...
Need help?
General
