Logika Technologies Inc. Model HMD-SM Operator’s Manual Rev 2.1 Dec-
13
Web: www.logikatech.com Phone: 905-829-5841 Fax: 905-829-8787 Email: info@logikatech.com
P a g e | 2
1. Introduction
The Logika Technologies scanning mode hot metal detector, Model HMD-SM, is
designed for the automation of steel, aluminum and other metal mill production lines. It
includes a rugged enclosure, protecting state-of-the-art electronics and will withstand
the harsh ambient conditions present in heavy industrial environments. The HMD-SM is
used to detect hot metal in a range of temperatures, shapes and sizes of wire, bar, strip,
thin plate, thick plate, billet, and slab production facilities.
The scanning mode feature allows the HMD to detect hot metal across the entire width
of a production line. It also enables the HMD to be installed remotely from the hot
metal target, further protecting the electronics and extending the life of the sensor.
2. Description
2.1 Model Nomenclature
HMD - SM - _Scan angle - Power Input__ - R
Base Model Scan angle Power Input R(Relay)
HMD-SM
10: 10 Degree 110: 110 VAC
1 Normal Open
1 Normal Close
30: 30 Degree 220: 220 VAC
50: 50 Degree 24: 24 VDC
Table 1
To Next Page
Loading...