7
Device Functions
When the device is first powered on, it will normally automatically attempt to connect to the Zigbee
Smart Home network. The System Indicator light will flash as it’s searching for the network. If it
connects, the light will remain on for 2 seconds and then go out.
If this does not happen, you can manually connect via the mobile app and follow the instructions
below.
Join the Zigbee Network
Press the SET button once. The System Indicator light will start flashing, signifying it’s searching for
the network.
When it successfully connects, the System Indicator light will stay solid for 2 seconds then go out.
Binding to Other Devices
This device can bind to other devices, like a remote-control button, by simply following the Binding
instructions in the mobile app, which will walk you through the process.
If the binding succeeds, the System Indicator will flash 3 times. On failure, it will flash 6 times.
Quit the Zigbee Network
Long press the SET button for 6 seconds. The System Indicator light will flash 4 times and go out. The
device has now been successfully removed from the network and been reset to the factory defaults.
To Next Page
Loading...