4. To assign a command to a mouse button, do one of the following:
o Double-click on the listed assignment to begin assigning a new command.
o Drag and drop an existing command from the Commands list in the left pane onto
a mouse button. When you drag a command over the button, the area will become
highlighted.
5. You can also right-click on a button or its assignment for additional options:
o Assign New Command — click to open the Command Editor window.
o Edit Command — click to open the Command Editor window.
o Use Generic — click to revert the command assignment to its original state.
o Unassign — click to remove all command assignments from the selected mouse
button.
On-Board Memory
1. Open LGS.
To Next Page
Loading...
