14
Testing your setup
Every time you update your Harmony 610, you should test your remote to ensure it’s working
the way you expect. This chapter gives you the information you need to test your remote. It
also has some suggestions on what to check while you’re testing your setup.
If you run into specific issues while testing your remote, refer to the Troubleshooting section of
this manual for suggestions and possible fixes for your problems.
The process of testing your Harmony 610 is straightforward. It involves simply trying the
Activities you use most often and then using the on-remote help to correct any issues.
In some cases, you may need to return to the Harmony Remote Software to make changes to
your remote’s setup to ensure the remote is working the way you want.
To begin testing your remote:
Ensure all the devices in your entertainment system are turned off.1.
Disconnect the USB cable from your remote.2.
Follow the instructions displayed on the remote’s screen.3.
Go to your entertainment system and try each of your Activities. 4.
For tips on what to look for when starting an Activity, or switching between Activities,
see the tips in this chapter.
Testing your setup – Starting an Activity
Look for these things in particular:
Did all of your devices for that Activity turn on?•
Do you hear the correct sound?•
If the Activity includes your TV, do you see the correct picture?•
Testing your setup – Switching between Activities
Look for these things in particular:
Are all devices needed for this new Activity on?•
Did devices not needed for this Activity turn off?•
Do you hear the correct Sound?•
If the Activity includes your TV, do you see the correct • picture?
If an Activity doesn’t start correctly, press the Help button on the
remote and the on-remote help will get you back “in sync”. After you
finish testing your Activities, be sure to re-test any for which you had
to use the Help.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
