Logitech Wireless Solar Keyboard K750
3 English
What’s in the box
Setting up the keyboard
1. Plug the Unifying receiver into a computer USB port.
For PC towers, use the Wireless extender to minimize
the possibility of radio frequency (RF) interference.
2. Pull the tab to activate the keyboard.
3. Turn on the keyboard.
How much light is needed?
The K750 requires only a modest level of light to operate and store energy. Indirect sunlight or indoor illumination is fine.
When exposed to dim room light on a continuous basis, the K750 has enough power for use. Because indoor
environments usually have periods of darkness, a moderate level of room lighting is recommended for much of the day.
The recharge time for the K750 is much less in brightly lit environments or when the K750 is placed in direct sunlight.
The K750 stores energy automatically, even when turned o. This stored energy allows you to use the K750 without light
for a while. With a full charge, the K750 can operate up to three months in total darkness before needing a recharge.
Checking for adequate light
How do you know whether there’s enough light for the K750? Use the Light-check hot key. The K750 tells you if
it’s getting enough illumination.
1. Make sure the K750 is turned on.
2. Press the Light-check hot key. The Light-check LED
will flash either green or red, or it won’t produce
any light at all. For more information, see Reading
the Light-check LED.
Wireless Solar Keyboard K750
Unifying receiver
Wireless extender
Cleaning cloth
2
3
1
USB USB
1 2
To Next Page
Loading...
Need help?
General
