Logitech ZONE 900 - ADJUSTING HEADSET; ADJUSTING THE MICROPHONE BOOM

PAIRING HEADSET, KEYBOARD AND MICE VIA USB RECEIVER
1. Download Logitech
®
Unifying Software at www.logitech.com/support/unifying
2. USB-A
Insert the Zone 900 receiver into the computer USB-A port.
USB-C
Insert the USB-A receiver into the USB-C adapter. Then insert the adapter into the computer USB-C port.
3. Zone 900 headset is already paired to the receiver it ships with. Just power on the headset. Once successfully
paired, the light indicator on the receiver will remain solid white. Light indicator on the headset will turn solid white.
4. To pair mice and keyboard,
a. Open the software and continue clicking “Next” on the bottom right corner. Ifyoualready have other unifying
receivers (with logo), please unplug them.
b. Locate the OFF-ON slider on your mice and keyboard. Turn each device o and back onto restart your devices
and nish pairing.
- If paired, please follow the on-screen prompt and test it out to conrm successful pairing.
- If pairing failed, please retry or refer to troubleshooting on our support page
www.logitech.com/support/zone900
NOTE: you can pair up to 6 Logitech Unifying peripherals.
ADJUSTING HEADSET
1. Adjust headset by sliding earcups up and down
theheadband.
2. It may be easier to adjust the headset on your head.
Movethe earcups up and down the headband until
theysit comfortably on your ears.
ADJUSTING THE MICROPHONE BOOM
1. Microphone boom rotates 270 degrees. Wear it on either
left or right side. Audio channel will switchautomatically,
depending on the direction you are wearing
themicrophone.
2. Flexible microphone boom — adjust boom location
tocapture voice better.
OFF/ON
www.logitech.com/
support/unifying
Advanced Next
USB-A
USB-C
5 English