8
TROUBLESHOOTING
PROBLEM SOLUTION
Top of tailgate hits cover when attempting
to close
• Verify side rail guide is set on top of box.
• Side rails are not level or set too low at
rear of cover, raise rails at rear of box
until cover no longer interferes with
tailgate operation (see Step 1).
Gap between cover and truck box or
tailgate
• Verify side rail guide is set on top of box.
• Side rails are not level or set too high
(see Step 1).
Seal on edge of cover is not sealing tight
with top of side rail and truck box
• Verify side rail guide is set on top of box.
• Check side rails for height and level
(see Step 1).
Latch doesn’t engage
• Check side rails for height and level
(see Step 1).
• Inspect latches for jammed or broken
parts.
Cover is not parallel with side rails
• With cover installed on box, loosen
hardware on both retainment brackets
with 7/16” wrench (DO NOT REMOVE
HARDWARE). Unfold cover to closed
position and square up with box.
Carefully fold cover back to open
position and retighten retainment
brackets’ hardware.
To Next Page
Loading...