10
Q: Film does not develop normally under very low temperature (<5 °C).
A: Use your hand to keep the lm warm after it has been ejected,
be aware not to put pressure on or bend the lm.
Q: Bright dots appear in the photo and they occur in the same
position in different photos.
A: Open the Back Door [9] of your LomoGraok and check the
roller located near the Film Ejection Slot [7] to make sure it
is clean and free of dust and dirt. Gently clean the roller if
required.
Q: The photo framing is different from how it appears on the
ground glass.
A: Check if the Film Plane Calibration & Mask Attachment [13]
is correctly installed, make sure the correct side is facing the
ground glass.
Q: Film is jammed while ejecting.
A: Make sure your LomoGraok is detached from the camera
while ejecting lm and Film Ejection Slot [7] is not blocked.
To Next Page
Loading...
