9
TROUBLESHOOTING
Q: The LomoGraok is functioning but the lm does not eject after
the Film Ejection Button [2] is pressed.
A: Please check the following:
• Make sure that there is lm installed in the camera.
• Check the Film Counter Window [8] to see if your lm has
come to an end.
• Make sure the LomoGraok is not set to “Off”.
• Check the battery power by checking the battery light inside
the Film Counter Window [8]. If it is not lit up, that means
your camera is running out of battery. You should insert fresh
batteries.
Q: I focused on the ground glass well but the photo is out of focus.
A: Make sure the Film Plane Calibration & Mask Attachment [13] is
installed correctly while focusing and the LomoGraok is
installed correctly on the camera while shooting.
To Next Page
Loading...
