Lomography LomoGraflok 4x5 Instant Back - Page 8

8
6. Your LomoGraok is now ready to use.
OPERATING LOMOGRAFLOK 4×5 INSTANT BACK
1. Slide in the Film Plane Calibration & Mask Attachment [13]
between the ground glass on your 4×5 camera and camera
body (the slot for inserting standard 4×5 lm holder).
2. Open the lens/camera shutter, adjust the camera bellows length
until you see an approximate sharp image on the ground glass
and focus your subject in detail.
3. Close the lens/camera shutter.
4. Remove the Film Plane Calibration & Mask Attachment [13].
5. Install the LomoGraok onto the Graok back of your 4×5 camera.
If the spring back on your camera can open 50 mm or more, you
may also simply slide in the LomoGraok for shooting.
6. Switch on the LomoGraok by switching the On/Off Switch [1].
7. Remove the Dark Slide [4] from the back.
8. Release the shutter and shoot.
9. Put back the Dark Slide [4].
10. Detach LomoGraok from the Camera.
11. Press the Film Ejection Button [2] to eject the lm.