Check before Operation
- 8 -
4. Check before operation
Routine inspection
Observe the leakage of engine oil and fuel.
Observe damage.
Check guard cover and cap position, and the tightness of screw, bolt and nut.
Check engine oil
After stalling, place the engine in level position, then check oil level.
1) Pull out the oil ruler and clean it.
2) Plug in the ruler thoroughly and take it out again to check the oil level.
3) If the oil level is lower than the low limit, remove the filler cap and fill the recommended
oil till it goes up to the top limit.
4) After filling, keep in mind to reinstall the ruler and tighten the cap.
To Next Page
Loading...
Need help?
General
