16
(1).Engine oil change
Drain the used oil while the engine is warm. Warm oil drains quickly and completely.
1) Place a suitable container below the engine to catch the used oil, and then remove the
filler cap/dipstick and the drain bolt.
2) Allow the used oil to drain completely, and then reinstall the drain bolt, and tighten it
securely.
3) With the engine in a level position, fill to the outer edge of the oil filler hole with the
recommended oil.
Please dispose of used motor oil in a manner that is compatible with the
environment. We suggest you take used oil in a sealed container to your local
recycling center or service station for reclamation. Do not throw it in the trash; pour
it on the ground; or down a drain.
(2).Clean/inspect engine oil filter
Remove the oil filter, clean oil filter or replace if damaged, and then install the oil filter.
(3). Air filter inspection
A dirty air filter will restrict air flow to the firebox, reducing engine performance. Lower the
clamp, remove the air cleaner cover and inspect the filter.
Operating the engine without an air filter, or with a damaged air filter,
will allow dirt to enter the engine, causing rapid engine wear.
Oil filter
To Next Page
Loading...
Need help?
General
