Chapter V Disassembly & Repair
- 33 -
Clean the carburetor
Note
1) Clean the carburetor with cleanser.
2) Blow in the compression air to remove dirt in idle air jet, idle jet, air jet, main jet, main nozzle, etc. prior to
installation.
Some chemical solvents are of relatively-strong corrosivity
and may damage plastic parts such as the O-ring and float.
Please carefully read the Solvents Manual. Should you not
confirm, don’t use the solvent to clean the carburetor. The
compression air of high pressure may also damage the
carburetor. Please remove the dirt in the passage or pipe
mouth with compression air of proper pressure.
When using the compression air, to avoid injury, wear
protective spectacles or other protective equipment.
Warning
To Next Page
Loading...
