Chapter V Disassembly & Repair
- 34 -
5-2-5 Flywheel and ignition coil
a. Disassembly/assembly
Flywheel puller
Disassembly:
Disassemble the ignition coil prior to the
disassembly of flywheel;
Do not tap the flywheel with hammer and
disassemble it with a commercially
available flywheel puller.
Assembly:
Clean the conical part of the crankshaft
and flywheel without engine oil or dirt
before installation.
Ignition coil
Assembly:
Prior to installation, check if the
insulation is cracked or damaged
so as to avoid electric leakage.
Charging coil
Flywheel
Torque: (22 ~ 30) N•m
Flange bolt M8 × 30
Regulater voltage
adjust
Torque: (90 ~ 115) N•m
Prevent the rotation of
flywheel with tool
during the disassembly
and assembly.
Flywheel bolt M12 × 35
Engine shround
Starter Motor
Connecting wire
Assembly:
Check wire insulation for
apparent damage. Use an
ohmmeter to check and
confirm each wire’s
continuit
To Next Page
Loading...
