and 7.5A adapters for 20W and 30W respectively.
Higher amperage output Power Adapter can be used
without risk of damage to your LASER B1.On inserting
the power barrel into your motherboard, it is possible
that a small spark is visible. This is NOT hazardous to
your machine and is caused by the 24V power inrush. If
you prefer to avoid this, connect the power barrel to
your motherboard first, then connect your power
adapter to the mains electricity plug.
• Once the LASER B1 detects 24V present you will see the
motherboard emit a light red glow on the LED of the
Motherboard. This mean the motherboard is powered.
• If when plugging your Power Adapter barrel to your
Motherboard and the Power adapter to mains power a
green LED does not turn on, please verify your power
adapter is receiving Mains Power.
To Next Page
Loading...
