(4) Machine assembly
The machine step-by-step assembly process is described in the
document “LASER B1 Quick Start Guide”. Please follow the guide to
assemble machine.
• During the machine assembly, if there is any unclear place,
please refer to the video “LASER B1 Quick Start Guide”.
• Each unit of the engraving machine has been inspected and
tested. Therefore, in some cases, very small traces may be
left on the profile and the metal shell. These will not affect
the quality. It is normal that it does not affect normal
engraving. Thank you very much for your understanding.
• Be cautious during assembly as some parts may have sharp
edges.
• If you have any questions after receiving the product, please
contact our customer service first.
To Next Page
Loading...
