Look R96 - FITTING THE SEAT POST HEAD

EN
SEAT POST FITTING THE
SEAT POST HEAD
1. Upper carriage
2. Spherical washer
3. Tightening bolt
4. Grooved pin
5. M5 x 60 bolt
6. Barrel
7. Spherical head nut
8. Lower carriage
9. Eye screw
10. Saddle rod head
11. Spacer
12. Seat tube cover
13. Seat tube
1
2
3
4
5
6
7
8
9
10
11
12
13
1. Place the cover (12) on the seat tube.
2. Stack the spacers (11) on the cover with
care to stacking direction:
3. Insert the barrels (6) into the holes of the
seat tube designed for that purpose.
4. Position the seat post head (10) on the
spacers.
5. Apply a LOCTITE 243 type product to the
threads of the two M5 x 60 screws (5).
6. Insert these screws into the head and
then screw them into the barrels in
place. Alternatively tighten the screw in
front and the one behind until a torque
of 8 Nm is reached.
Arrows to the front
of the bicycle
Fig. 2
15