LORD D5 - Water Softener; Adjusting Salt Consumption

6
Water Softener
Thewatersoftenermustbesetmanually,usingthewaterhardnessdial.
Thewatersoftenerisdesignedtoremovemineralsandsaltsfromthewater,which
wouldhaveadetrimentaloradverseeectontheoperationoftheappliance.
Themoremineralsthereare,theharderyourwateris.
Thesoftenershouldbeadjustedaccordingtothehardnessofthewaterinyourarea.
YourlocalWaterAuthoritycanadviseyouonthehardnessofthewaterinyourarea.
Adjusting salt consumption
Thedishwasherisdesignedtoallowforadjustmentintheamountofsaltconsumed
basedonthehardnessofthewaterused.Thisisintendedtooptimiseandcustomise
thelevelofsaltconsumption.
Pleasefollowthestepsbelowforadjustmentinsaltconsumption.
1. Closethedoor,switchontheappliance;
2. Within60secondsaftertheappliancewasswitchedon,presstheProgramme
buttonformorethan5secondstostartthewatersoftenersettingmode;
3. PresstheProgrambuttonagaintoselectthepropersettingaccordingtoyourlocal
environment,thesettingwillchangeinthefollowingsequence:
 H1->H2->H3->H4->H5->H6;
4. WithoutanyoperationinvesecondsorpressthePowerbuttontoendthesetting
mode,thesettingismemorizedbytheprogramme.
WATER HARDNESS
Setting on the
water softener
Digital
display
stalls
Regeneration occurs
every X program
sequence 3)
ºdH
1)
mmol/l
2)
0-5 0-0,9 1 H1 Noregeneration
6-11 1,0-2,0 2 H2 10
12-17 2,1-3,0 3 H3 5
18-22 3,1-4,0 4 * H4 3
23-34 4,1-6,1 5 H5 2
35-45 6,2-8,0 6 H6 1
1) Germandegreeofmeasurementforthewaterhardness
2) millimol,internationelunitforwaterhardness
3) Everycyclewitharegenerationoperationconsumesadditional2.0litresofwater,
theenergyconsumptionincreasesby0.02kWhandtheprogramextentsby4
minutes.
* factorysetting