HOW TO USE
ASSEMBLY APPLIANCE PROPERLY BEFORE USE
Fig. 1 Fig. 2
Fig. 3 Fig. 4
Fig. 1 Place the hose connector in front of the vacuum cleaner. Then insert it into the inlet hole
and turn it right. If you want to disassemble it, turn the hose connector left and then pull it
out.
Fig. 2 Hold the flexural connector of the hose and put it into the bigger hole of the tube.
Fig. 3 Put the metal tube into the hole of the nozzle to fasten them.
Fig. 4 Pull the power cord out of the appliance and stop it when you see the yellow mark. Make
sure the red mark is not out of appliance. When your vacuuming is finished, first turn off
the appliance, pull the plug out of the socket, and then push the rewind button until the
cord is completely in the appliance. Hold plug when retracting the cord
ENGLISH
26
To Next Page
Loading...