EasyManua.ls Logo

Lorentz PowerPack 4000S - Safety Instructions

Lorentz PowerPack 4000S
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 Introduction
1 Introduction
Thank you for purchasing a LORENTZ product.
Before you begin – Please check the product label to
verify that this is the item you ordered. To ensure the
product is appropriate for your application please
check the product specications.
In addition to this manual, manuals for the pump
end, controller and all other components used in
your system should also be read.
2 Safety Instructions
Safe operation of this product depends on its correct
transportation, operation and maintenance. Failure
to follow these instructions can be dangerous to life
or health and/or void the warranty.
PLEASE READ AND FOLLOW
ALL INSTRUCTIONS!
Explanation of warning symbols
l
WARNING – Disregard can lead to
injury, death or damage the system.
a
CAUTION – Recommended to avoid
damage, premature aging of the pump or
similar negative consequences.
When installing and using the electrical equipment,
basic safety precautions should always be followed,
including the following:
l
WARNING – To reduce the risk of
injury, do not permit children to use this
product.
WARNING – The equipment is not to
be used by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless otherwise instructed
and closely supervised.
WARNING – It must be ensured
that all grounding connections are
properly made and that the resistance
towards ground meets local codes and
requirements.
WARNING – To reduce the risk of
electric shock, replace any damaged cords
and cabling immediately.
This manual contains basic instructions which must
be observed during installation, operation and
maintenance. The manual should be carefully read
before installation and use of the product by the
person in charge of the installation. The manual
should also be read by all other technical personnel/
operators and should be available at the installation
site at all times.