EasyManua.ls Logo

Lorentz PS1800 User Manual

Lorentz PS1800
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
PS200
PS600
PS1200
PS1800
INSTRUCTIONS FOR
INSTALLATION
OPERATION
SERVICE
Bernt Lorentz GmbH & Co. KG
Heidekoppel 16
D-24558 Henstedt-Ulzburg
Germany
Tel. ++49.4193.7548-0
Fax ++49.4193.7548-29
www.lorentz.de
release 07/08/05
SOLAR WATER
PUMP SYSTEMS

Table of Contents

Other manuals for Lorentz PS1800

Question and Answer IconNeed help?

Do you have a question about the Lorentz PS1800 and is the answer not in the manual?

Lorentz PS1800 Specifications

General IconGeneral
BrandLorentz
ModelPS1800
CategoryWater Pump
LanguageEnglish

Summary

1 Warnings and Safety Precautions

2 System Report Form

4 Installing the Solar Array

4.1 Location of the Solar Array

Guides on selecting an optimal location for the solar array, emphasizing full sun exposure and avoiding shading.

4.3 Solar Array Mounting Rack

Details requirements for the mounting structure, including wind resistance and safety, and mentions solar trackers.

4.4 Orienting the Solar Array to Solar South

Explains how to orient the solar array for maximum performance, using a sun compass and magnetic declination.

4.5 Setting the Solar Array Tilt Angle

Provides guidance on adjusting the solar array's tilt angle seasonally or for year-round compromise based on latitude.

5 Electrical Installation Procedures

5.1 Controller, Junction Box, and Conduit

Covers placement, mounting, and protection of the controller, junction box, and conduit for electrical safety.

5.2 Grounding and Lightning Protection

Details critical steps for system grounding and lightning protection to prevent damage and ensure safety.

5.3 Solar Array Wiring

Explains how to safely connect solar modules, including wire types, connections, and tracker wiring considerations.

5.4 Solar Array Disconnect Switch in the Junction Box

Describes the function and use of the disconnect switch for safety during installation and maintenance.

5.5 Junction Box (Controller Input) Wiring

Provides instructions for wiring the controller's input terminals, including power, pump, and sensor connections.

5.8 Wiring Order for Correct Rotation

Details how to ensure correct motor rotation for helical rotor and centrifugal pumps, including testing procedures.

5.9 Low-Water Probe for Dry-Run Protection

Explains the function and installation of the low-water probe to prevent pump damage from running dry.

5.10 Automatic Control For Full-Tank Shutoff

Describes how to use float switches or other means for automatic tank shutoff to prevent overflow.

6 Preparing to Install the Pump

7 In-Well Assembly and Installation

8 Operating the Pump

9 Troubleshooting Guide

9.1 If The Pump Doesn't Run

Provides troubleshooting steps for scenarios where the pump fails to start or operate correctly.

9.2 Inspect The System

Guides on performing visual inspections of the solar array, wiring, and components to identify potential issues.

9.3 Electrical Testing Procedures

Details various electrical tests using multimeters and clamp meters to diagnose system faults.

9.4 Troubleshooting Reduced Flow

Addresses issues where the pump runs but delivers less flow than expected, identifying potential causes.

10 Maintenance Recommendations

13 Reference Section

13.11 System Wiring Diagram for Solar-direct Systems

Illustrates the system wiring diagram for solar-direct configurations, showing connections for panels, controller, and pump.

Related product manuals