7.7 PS2 pool pump systems
NOTE – The following chapter is relevant
for PS2 controllers operating pool pumps
only.
WARNING – The use of pumps for
swimming pools and the restricted area
around them is only permitted if pumps
are installed in accordance with DIN/VDE
0100 part 702 or other local standards.
Please consult your licensed electrician!
WARNING – A cord and plug connected
unit shall be provided with a permanently
attached flexible cord of a water-resistant
type, e.g. SEW, SEOW, SJW, SJOW, SJEW,
SJEOW, SJTW, SJTOW, SOW, STW, or STOW.
When the pump is connected by cable, use
extra-hard type (toughened) cable for
connections.
WARNING – When the motor is installed
within 1.5 m/5 ft of the inside walls of a
swimming pool, spa, or hot tub, a
solid-copper bonding-conductor not
smaller than 8.4 mm²/AWG 8 must be
connected from the accessible wire
connector on the motor to all metal parts
of the swimming pool, spa, or hot tub
structure and to all electrical equipment,
metal conduit, and metal piping within
1.5 m/5 ft of the inside walls of the
swimming pool, spa, or hot tub.
Before start-up of the pool pump system manually configure
the controller to the correct pool pump end with PumpScan-
ner. Please refer to the PumpScanner manual on partnerNET.
7.8 PS2 boost pump systems
NOTE – The following chapter is relevant
for PS2-150 controllers operating boost
pumps only.
Before start-up of the boost pump system manually set the
system to the correct boost pump end with PumpScanner.
Please refer to the PumpScanner manual on partnerNET.
CAUTION – starting the boost pump
without selecting the correct boost pump
end will damage the pump. Such damage
is excluded from the warranty.
To Next Page
Loading...
Need help?
General
