INSTRUCTIONS FOR USE
Translation of the original instructions
22
5.3 Starting the main burner and adjusting the temperature
· Turn the knob into position to set the burner to maximum
· Turn the knob into position to set the burner to minimum
5.4 Switching the main burner off
· Turn the knob into position . The burner turns OFF and only the pilot flame remains ON
5.5 Switching the appliance off
· Press and turn the gas cock knob to position "0". This control blocks the gas supply to both the main
burner and the pilot burner
5.6 Emptying the tank
To perform this operation, open the drain tap (lever in vertical position) which can only be reached from the
door of the cabinet underneath the appliance
Note
It is advisable to perform this operation using water that is not excessively hot
5.7 Pasta cooker with automatic loading
If the probe does not detect water in the tank, the system resets the correct level and after 15 sec. disables
the heating element: an alarm is signalled by the red indicator light flashing. When the probe detects water
again, the heating element is immediately activated and after 3 sec. automatic refilling is interrupted. The
system monitors the filling phase through a TIME-OUT.
· Slow refilling button
When the "slow refilling button" is active, the system fills the tank slowly to prevent possible foaming
· Level button
To Next Page
Loading...
Need help?
General
