Introduction
Congratulations on your new Lotus Wood Stove
We sincerely trust that your Lotus Wood Stove will bring many happy hours
for you. However, to benefit fully from your investment, you should read these
instructions thoroughly. They contain some specific advice on how to benefit
fully from your stove – now, and in the years ahead. So, like all other directions
for use, keeping them in a safe place would be a good idea.
Lotus Wood Stoves are based on a long tradition; the first productions were
way back in 1979. Our production is now run in Langeskov on Funen in
Denmark, and is exported to a great many European markets. Our stoves are
produced to sound Danish tradition, and have given their owners good and
reliable service for years. So, once again, congratulations on your new Lotus
wood stove. We feel certain that putting your Lotus wood stove in operation
will inaugurate a warm and cosy beginning of a new home life for you.
This stove is intended for ”intermittent combustion”, a process achieved by
following the instructions of the guide below under ”Use of Stove”.
Mounting of Stove
Before your new stove will be ready to exude warmth and cosiness, you should
read these pages thoroughly. Pages reviewing the requirements for the
mounting and for the surroundings. Reference is also made to the fact that local
regulations, including those referring to national and European standards,
applying at all times must be met for the installation of your wood stove.
A warning should also be issued against any unauthorized change of your wood
stove. It should be added that the surfaces of your wood stove will become hot.
Lotus recommends that your stove be mounted by an authorized Lotus
distributor or by a fireplace service man recommended by an authorized Lotus
distributor.
NOTE: Your stove may not be put into use until the installation has been
approved by the local chimney sweep.
Further, please note that any air grates are to be placed so as not to block.
To Next Page
Loading...
Need help?
General
