Sterilization water
Requisitely make sterilization water 2~3 times a week
① Fill the hydrogen water pot with tap
water as 1.8liter max.
② Gently touch the touch power button for
3 seconds, and “cleaning” flickers on and
operation time will be set at 15 minutes
with red lighting.
③ Do not drink the sterilization water.
④ Until taking out the pot from the machine
after the running cycle, the machine will
generate ozone bubble slightly with red
lighting.
The sterilization water contains ozone, hypochlorous acid and chlorine peroxide mainly.
Somewhat fishy smell can be caused from ozone gas.
Use the sterilization water for removal agricultural chemicals from fruits, vegetables and
for general cleaning and sterilization.
The dissolved ozone will decompose quickly, and recommended to use it in 30 minutes.
To make stronger and longer maintained sterilization water, you can dissolve 1/3
teaspoon of salt in water before operation. In this case sterilizing power can be
maintained for 24hours.
MIN
CLEANING
HYDROGEN SPRING WATER
15
blinking
Touch over
3 seconds!
Essential sterilization water operation
It is essential to run the sterilization mode to remove the mineral scale from the electrode.
The mineral scale which is stuck while making the hydrogen water will be a main cause
for breakdown of the machine.
If there are lots of minerals or white stuff on the electrode, pour 500ml of tap water into
the pot and dilute 5g of citric acid. After that operate sterilization water mode to clean the
electrode. The mineral will be eliminated.
21
To Next Page
Loading...